The gear reducer is a lot of users. It is not very clear. How to install the gear reducer, what is the steps of installing the gear gear reducer?

1. When installing the gear reducer, it should be emphasized in the transmission center axis pair, and the error is not larger than the use of the coupling used.

2. When the drive is mounted on the output shaft, the hammer is not allowed to be tapped, which is typically used to press the drive by the inner thread of the assembly jig and the shaft end.

3. The gear reducer should be firmly mounted on the base or base of the stable level, and the oil of the drain tank should be excluded, and the cooling air is smooth. The foundation is unreliable, and the vibration and noise will cause the bearing and gear when the base is not reliable.

4. The gear reducer is lubricated with the oil pool, and the user needs to take the spline of the vent, replace the ventilator. Press different installation locations and open the oil level line to check the height of the oil level line.

5. Make sure the staff can easily close the oil label, ventilation, drainage plug.

When we use the gear reducer, we can follow the installation steps above, properly installing our speed reduction machine is what we need.